Polaris General 1000 AArm Guard Set

NOTE: The font cut-outs shown in pictures above are not accurate. We do not have any accurate pictures at this time.


Let's take a moment and think about your most recent outing to your local trail system or local riding area. Alright now take a moment and think about how the rocks, logs and even debris that you were busy driving across. Think about how your front and rear a-arms and axle shafts were left unprotected from unwanted and expensive damage that's sure to occur. Well now let's talk about how to protect your machine from that unwanted damage with these Front and Axiom Front and Rear A-Arm Guards for your Polaris General 1000.

These Axiom a-arm guards are made from 5/32" aluminum and feature a brushed aluminum finish that is sure to look good on any machine. The guards feature a design that installs quickly and easily on your machine with no modifications required to your factory equipment. The guards also install on your General with the included square shouldered low profile bolts to prevent unwanted snags and shearing of the bolts while you are out on the trails. So if you are looking for a way to protect the expensive a-arms and axle shafts look no further then this all-inclusive kit for your Polaris.


Features:

• Made from 0.160 (5/32") thick aluminum
• Brushed finish
• Drainage holes and slots for easier cleanout
• Square shouldered low profile bolts prevent heads from shearing off
• Easy installation
• No modifications required
• Installation hardware and clamps are included