NOTE: The steering column mounted turn signal switch is the safest and easiest to operate. We always recommend that you install a steering column mounted turn signal switch kit on a UTV / side-by-side if you have the steering column space, for your added safety. A steering column mounted turn signal switch is located in the same area as your automobile, and comes natural for activating while keeping your eyes on the road.
Applicability: 2018-20 Can Am Maverick Trail and Maverick Trail DPS
Regardless of where you ride, there may come a time when you want to ride on the pavement. That's why you should consider upgrading with a UTV turn signal kit. The aftermarket accessory is almost always on the street-legal requirements list, because of the necessary safety precautions for you and other drivers. Side By Side Stuff has an impressive selection of various Can Am systems that have different features and installation processes. If you want cost-efficient and that D.O.T. approved rating, the Maverick Trail Turn Signal Kit with Toggle Switches is the right upgrade for you.
Everything comes provided in this kit: four LED turn signal lights, two toggle switches, two indicators, LED flasher, fuse, fuse holder, wiring and connector kit. This is an independent system that does not operate using OEM wiring or rear lights. That means installation is going to take some elbow grease and time. However, EZTSK did include a detailed diagram along with the instructions, giving precise direction for the colored wiring. Get road ready offroad outlaws by shopping Can Am D.O.T. approved parts and accessories, at Side By Side Stuff.Features:
- (2) amber and (2) red super bright DOT approved LED turn signal lights (3/4" diameter)
- (2) toggle switches + 2 LED indicator lights for the turn signals and 4-way emergency flashers
- LED flasher, fuse holder and Fuse
- TS wire and connector kit
- Detailed diagram with instructions
- Street legal turn signal kit
- Doesn't use OEM rear lights for rear turn signals, works completely independently
- The 4 LED turn signal lights are 3/4" round with attached rubber grommet for quick mounting, they are surface mounted with no brackets required.
- LED flasher has 3 pin connections for load, pilot and power
- Does NOT go in factory wiring and is a completely independent system
- Wiring diagram and instructions shows where each colored wire goes