- Does NOT fit Can Am Maverick X3, Polaris RZR XP Turbo S or 2019 Polaris RZR models
- This kit comes with 1 Strobe rocker switch only. Please see options to purchase additional switches/switch covers.
- Optional Switch plate will only fit RZR models with an analog/round speedometer.
- Optional Switch Plate Applicability: 2014-17 Polaris RZR XP 1000 / RZR XP Turbo / RZR S 1000 / RZR XP 4 1000 / RZR XP 4 Turbo and 2015-17 Polaris RZR 900 / RZR 900 XC / RZR S 900 / RZR 4 900
Adding aftermarket accessories to your ride is one of the great aspects of owning a UTV. Unfortunately, with those accessories comes wiring and sometimes quite a bit of it. If you are wanting a power control system that is quick and easy to install and won't leave straggling wires hanging out all over your side by side, then this is a great item to consider! The XTC 6 Circuit Power Control System not only controls your accessories, but it also adds a two channel strobe system so you can personalize your side by side.
A plug and play harness is utilized for an easy installation and a significant reduction in time required adding this item to your machine. With a barrier strip for clean integration and diode protection that reduces voltage spikes from field collapse, the XTC power control system offers protection for the accessories that you have hooked to it. Be sure to check all of the options to ensure that you are getting the customized kit that you have been searching for! If you have any questions about this product or any others, please give us a call, we're here to help!
1 - Plug & Play factory style 6 switch harness w/ 2 15" switch extensions for more panel options
2 - High power 20 amp relay circuits
3 - 10 amp direct circuits
1 - 2 channel flasher system
1 - Fuse block w/ power cable
Easy install reduces installation time significantly
Diode protection that reduce voltage spikes from field collapse
Wired for bottom row lighting
Barrier strip for clean integration
Fuse block with each circuit on its own fuse
8GA power cable with main circuit breaker at battery for overall circuit protection
2 x 20 amp relayed circuits
3 x 10 amp direct circuits
1 x built in 2 channel flasher circuit with switch to change patterns
Optional Diode for Flasher Systems
The Optional Diode for Flasher Systems is used to move your flasher system to a light that is to be used as a solid or flashing light; letting power go in only one direction.
Optional RZR Rear Tail Lights Integration
The Optional RZR Rear Tail Lights Integration cable allows for the Power Control System to plug into the rear tail lights of your machine to make them flash. Also included are 3 extra auxiliary wires which provide the option to add whip lights, rear lights and more!