Applicability: Fits

• 2015-20 Polaris RZR 900 / RZR 900 XC / RZR S 900 / RZR 4 900 and RZR S 4 900
• 2016-20 Polaris RZR S 1000 and RZR S 4 1000

Depending on how rough you like to play in your Polaris RZR S 900 sometimes a stock air intake just won’t do the job. No matter how hard you try to take care of it, you still get dust particles in your filter and one day that dust could get into your motor causing you a very large bill. If you’re into new technology, S&B Filters has a new product just for you. With their Particle Separator S&B Filters used the latest technology to create an aftermarket accessory that takes protecting your engine to a whole new level!

This awesome item attaches directly into the stock intake system of your UTV acting as a pre-filter for the entire system. The separator was designed to work at an efficiency rate of 94% to remove dust from the air being pulled in and fed to the air box of your side by side. The dust particles the separator pulls in fly out an exit tube while the clean air goes directly into your intake system. Installation only takes approximately two hours and the manufacturer included a 5-year limited warranty so you’re covered if something may happen.

Features:

• Product dimensions: 20.2" wide x 10.5" high x 10" deep
• Weighs 11 lbs.
• Duct length of 39"
• Clamp diameter of 1.75"
• Efficiency rate of 94%
• Amp draw of 3.1 amps
• Attached directly to the stock intake system
• Installation takes approximately 2 hours
• Manufacturers 5 year limited warranty

 View Installation Instructions