Lower and Recline Seat Base by Longhorn Fab |Sold in Pairs| - Polaris General 1000 | XP 1000

NOTES:
- Sold in Pairs
- Pictured above product is on Polaris RZR, will work the same for Polaris General
- Does not raise front of seat in order to increase recline
- Does not allow for the use of a factory slider. Recommended setting the passenger and driver seat at different adjustments and swapping seats with the driver.
- Installation of the seat base requires some trimming to the plastic where the seat base sits down on the frame.
- For 4 seater vehicles, to order for both front and rear, select quantity two (2).


Applicability: 2016-21 Polaris General 1000 / General XP 1000 / General 4 1000 / General XP 4 1000


When it comes to your Polaris General there are many things you love about it, the power and utility features are just a few to mention. However, when it comes to rider comfort, there are a few things about it you wish you could change. You might find that the stock seat bases have a tendency of making it uncomfortable, and harder to accommodate riders and passengers of all sizes. Here at Side By Side Stuff we offer you a solution with the Lower and Recline Seat Base by Longhorn Fab.

Factory seats sit at a 22-degree angle, but with the Longhorn Fab base you gain additional 6 degrees over stock, making the riding position even more comfortable then before! By changing the pitch at which the seat is sitting, this lowers the seat back 2 inches, increasing that well needed head room. Manufactured out of CNC bent and laser cut steel, you will receive a product that has been made with quality in mind. Thanks to Longhorn Fab’s dedication to quality, you won't need to be worried about extensive installation procedures, because all the necessary hardware is included. Get more comfortable while tearing up the trails, and order yours today!


Features:

• Creates a more comfortable riding position
• Lowers seat back 2"
• Reclines 6 degrees over stock (28 degrees in total recline)
• Adjustable
• Light weight for less added weight
• Light weight design does not compromise structural integrity
• Made from 0.125" laser cut steel
• CNC bent
• Powder coated for durability
• Latches and unlatches seat quickly from the front
• Perfect for machines with chopped or lowered cages
• Fits front and back seats
• All necessary hardware included

 View Installation Instructions