CF Moto CForce 800 XC Front Bumper
SSL Secured
Expert Support
Fitment
- 2021 CFMOTO CForce 1000 Overland
- 2022 CFMOTO CForce 1000 Overland
- 2018 CFMOTO CForce 800 XC
- 2019 CFMOTO CForce 800 XC
- 2020 CFMOTO CForce 800 XC
- 2021 CFMOTO CForce 800 XC
- 2022 CFMOTO CForce 800 XC
Important Info
- Cannot ship outside the lower 48 states
Customer Reviews
Product Reviews
Rival front bumper, February 8, 2021
Not great, July 12, 2020
Not great, June 24, 2020
Posted By: Ron pryce
As you've read in the other comments.. Not a great fit.. After a couple hours and a little bleeding..I gave up.. after you get one bolt in.. The rest won't line up.. Even used pry bars, jacks and allot of language I probably shouldn't have.. But now it's in the corner until I decide to bring it to the scrap, or cut and weld it so it fits.. Not recommended..I would expect this if it were half the price it's selling for!
As you've read in the other comments.. Not a great fit.. After a couple hours and a little bleeding..I gave up.. after you get one bolt in.. The rest won't line up.. Even used pry bars, jacks and allot of language I probably shouldn't have.. But now it's in the corner until I decide to bring it to the scrap, or cut and weld it so it fits.. Not recommended..I would expect this if it were half the price it's selling for!
Not so good for the price, July 20, 2019
Posted By: Tim Russell
4 people found this review helpful
Arrived just wrapped in shrink wrap. All flanges had worn through the wrap and rubbed the paint off of almost every corner. The fit is terrible, had to use floor jacks and a bottle jack to get it to line up. After all the jacking around and even had to use a 3 foot pry bar to get the bolts to line up, both the front and rear bumper are on the machine crooked. The down tube on both bumpers were either bent or not bent and welded alike. After mounted on the ATV they where tilted and leaning with almost no adjustment to make it look straight. Would not buy again.
4 people found this review helpful
Arrived just wrapped in shrink wrap. All flanges had worn through the wrap and rubbed the paint off of almost every corner. The fit is terrible, had to use floor jacks and a bottle jack to get it to line up. After all the jacking around and even had to use a 3 foot pry bar to get the bolts to line up, both the front and rear bumper are on the machine crooked. The down tube on both bumpers were either bent or not bent and welded alike. After mounted on the ATV they where tilted and leaning with almost no adjustment to make it look straight. Would not buy again.
Click here to review this product
(Reviews are subject to approval)
(Reviews are subject to approval)
Questions & Answers
Warning: Cancer and Reproductive Harm For more information, go to www.P65Warnings.ca.gov