NOTE: There are currently no accurate photos of the product in manta green.
Applicability: 2017-21 Can Am Maverick X3 (See options above)
There are a million reasons why you may want to outfit your ride with aftermarket control arms. Sure, factory units will do, but if you want more flex and clearance, you're going to need something with more rigidity for the push. Side By Side Stuff has a massive supply of Can-Am suspension parts and lift kits that will have you shredding, ripping, or crawling like never before. One assembly that will give you the inches and the length you're looking for is the Maverick X3 APEXX Front Forward Upper and Lower Control Arms by High Lifter.
Before we dive into the "what you get," can we take a moment to appreciate this built for battle build? We're talking extreme-duty DOM steel and heavy-duty ball joint brackets, just to give you a taste. This unit can handle the offroad stress and then some. Then factor in the camber adjustability and optimize sway bar linkage angles. You're getting articulation for days with the durability to back it up. High Lifter tops the UTV control arms off with a powder-coated finish for good measure. So, you can add corrosion and wear-resistant to the mix too. Get your flex on when you shop Can-Am Maverick X3 parts and accessories at Side By Side Stuff.Features:
Optional High Lifter Pre-Installed Ball Joints:
- Adjustable heat treated collars for camber adjustability with a 1 inch thread
- Raked forward 1.5 inches
- Over 3 degrees of camber adjustment in each direction
- Heavy duty ball joint brackets to eliminate deformation issues
- Ladder bar compatible with the 1.5 inch ID clamps
- Extreme duty 1.5 inch x 0.120 inch DOM steel construction
- 2 inches of added ground clearance compared to OEM lower arm
- Mounting accommodations for OEM brake lines using OEM tabs instead of P-clamps
- Optimized sway bar linkage angles
- Limited lifetime warranty - excludes wearable items such as bushings, bearings, cones and heim joints
- Powder coated
High Lifter made installing your new control arms easy with the pre-installed ball joints. Manufactured from 4130 chromoly steel, these ball joints are 3 times stronger than the OEM ball joints and use lithium grease! Not only are these a direct OEM factory replacement part, they are durable and tough with the long lasting zinc plated finish! Don't stress about replacing the upper and lower ball joints yourself, let High Lifter do it for you!
Optional High Lifter APEXX Pre-Installed Ball Joints:
High Lifter stepped up the game when it comes to installing your new control arms with the APEXX pre-installed ball joints. They are manufactured from 4340 chromoly steel and are 2 times stronger than OEM ball joints! These ball joints are fully serviceable and rebuildable for increased longevity and reliability. If you're looking for a great replacement for your worn out ball joints, grab a set for your upper and lower joints today! View Warranty Information
This product can expose you to chemicals including Titanium Dioxide, which is known in the State of California to cause cancer and birth defects, or other reproductive harm. For more information, go to www.P65Warnings.ca.gov