Polaris RZR XP 1000 Turn Signal Kit

NOTES:
- Standard Harness DOES NOT fit 2017-21 RZRs that came with FACTORY Installed Ride Command
- If you have FACTORY Installed Ride Command you will need the Ride Command Rear Harness.
- Kits will vary by model.


Applicability: Fits

• 2014-23 Polaris RZR XP 1000 / RZR XP Turbo / RZR XP 4 1000 / RZR XP 4 Turbo
• 2015-20 Polaris RZR 900 / RZR 900 XC / RZR S 900 / RZR 4 900 / RZR S 4 900
• 2016-20 Polaris RZR S 1000 and RZR S 4 1000

Being able to drive your RZR XP 1000 out of the garage to your favorite trail is cool, but being able to hop in it and cruise down the road to your local pizza joint, well now, that’s awesome! The most common requirement for making your machine street legal is installation of a horn and turn signals. All states have their own requirements for street legal equipment, so be sure to check with your local Department of Motor Vehicles (DMV) or Motor Vehicle Division (MVD), for your local requirements. If your state will allow it, then this XTC Turn Signal Kit with Horn is the first step to burning rubber on asphalt.

XTC knows your RZR XP 1000 is primarily used for off-road riding, that’s why they opted to use a lit switch on the dash instead of those large awkward levers that break off easily. The plug and play kit requires no wires to be cut and no crimping. All you do is hook up the power and ground and plug into your OEM harness. Since your factory lights are larger than the 3/4” markers most kits use, the XTC Turn Signal Kit with Horn uses your factory brake lights as turn indicators, making it much safer to be seen. This kit also includes a lit hazard switch and rear power out for the optional 6 inch, 6 LED license plate frame. By installing the right aftermarket accessories, you can really take your side by side on every type of terrain: from pavement, to off-road trails, and back again.


Kit Includes:

• 1 - Turn signal controller
• 1 - Front harness
• 1 - Rear harness
• 1 - Carling lit turn switch
• 1 - Horn
• 1 - Switch housing
• 1 - Lit horn/emergency hazard switch
• 2 - 3/4" front LED's
• 2 - Self tapping screws
• 15 - Cable ties
• 1 - Installation instructions

Ride Command Rear Harness:

If your 2017-20 RZR came with Factory Installed Ride Command, you will need this option for your new XTC Turn Signal Kit to work correctly. Please verify that you have a 8 Way Rear Wire Harness with 7 wires before ordering. If you had Ride Command installed at a dealership or installed yourself, you WILL NOT need the Ride Command Rear Harness. If you have any questions about whether or not you need the Ride Command Rear Harness, please call before ordering.


Optional License Plate Frame Features:

• Plug N Play adapter with 3' power wire
• 2 heat shrinkable butt connectors
• 3 cable ties
• Outside dimensions: 7.25" x 4.21"
• Plate dimensions 7.1" x 4.1"
• Center to center mounting hole: 5.7"
• Mounting hardware included